12 kw pellet boiler with condensing efficiency
Thirteen Five release plan indicates that China's move towards green development pace firmer, Beijing SASAC Building Materials Service Center from its start, the use of green 12 kw pellet boiler with condensing efficiency heating for low nitrogen as the primary task before the onset of winter. SAC Building Materials authorities after preliminary investigation and after the screening, the other fast boiler R & D experience in the field of boiler cleaning two decades expressed appreciation can, in August 2017 signed a five Thalia T6 series one boiler and two vacuum with fast Boiler condensing gas boiler products contract.
How to adjust the phenomenon of low pressure 12 kw pellet boiler with condensing efficiency furnace 1, boiler furnace low pressure alarm. 2, the furnace pressure display abnormally low. 3, when the furnace pressure low -2.4kPa, MFT operation. 1 reason, some or all of pulverizing system failure. 2, a fan, blower trip. 3, boiler MFT. 4, furnace pressure automatic control failure. 5, an air preheater, a secondary air damper, blower / motor primary leaf and air outlet damper closed. 6, the blower trip, the corresponding side of the induced draft fan is not tripping. 7, the induced draft fan, booster fan automatic failure, sudden increase in the degree of opening. 1 should be immediately treated, such as furnace pressure value reaches the MFT is not adjusted normal furnace pressure. 2, the automatic control furnace pressure failure, immediately cut automatic and manual adjustment, the adjustment process to guard against the fan surge. 3, investment and oil combustion stable combustion. 4, the tripped blower, draft fan not corresponding side of tripping, the induced draft fan shutdown immediately. 5, when an air preheater, a secondary air damper, blower / motor primary leaf and air outlet damper closed, should immediately resume-on. 6, a fan, blower, air preheater, pulverizing system fault, should adjust the normal furnace pressure. 7, if the MFT, MFT press process.
According to the relevant data show that the low temperature waste heat power generation mainly using low temperature steam turbine power generation system which is consist of low temperature waste heat 12 kw pellet boiler with condensing efficiency and steam turbine.Whether it is design or manufacturing equipment, technology is relatively mature, has been popularized in power, metallurgy, building materials, light industry and other industries, such as cement kiln waste heat power generation industry furnace, sintering waste heat power generation,waste heat of dry quenching power generation industry, glass, ceramic tiles and other building materials kiln flue gas waste heat power generation.
A correct steam 12 kw pellet boiler with condensing efficiency shutdown: 1, the steam boiler is not used to determine, fireman and support staff to coordinate Division, before proceeding shutdown operation. 2, to reduce fuel (coal), and then reducing the amount of wind, until after the load falls to zero, closing the main valve and stop the air blowing, the wind is stopped after 5 minutes. 3, the shutter closing the flue, each door seal, manholes. 4, the boiler flame, when the vapor pressure exceeds the working pressure, exhaust valves should be opened or add water to the boiler and the blowdown, but should not significantly cooled boiler. 5, boiler pressure is not reduced to zero, to maintain the normal water level, the operator may not leave their posts until the pressure to zero, then make sure all links are correct before they show proper steam boiler shutdown.