boiler with steam output 17 5 bar steam boiler
Directly under the Central Government Offices Administration (referred to as the straight Authority) is the CPC Central Committee and subordinate units, are responsible for the CPC Central Committee and services for the organs and services, an important function of serving the people. Central Government institutions funds, finance, public service vehicles, the state-owned assets and real estate management, service management is responsible for the specified life of the party and state leaders as well as services related objects.
10 tons SZS mills gas boiler with steam output 17 5 bar steam boiler production and processing of textile industry are inseparable and steam boilers. Many production processes need to use, such as dyeing or dry. Dyeing factory furnace will choose different sizes according to the scale of production. 10 tons of gas steam boiler used in textile mills there are two main types: a 10-ton W gas fired steam boiler. The use of advanced technology, so in a leading level in the industry. The main body of the boiler of the boiler, connected to the stack, the burner, soda, systems, instrumentation, economizer, a condenser, and the like. Safe and stable operation, stable and efficient operation, better combustion, no pollution emissions clean. Not only can be used in textile mills, can also be used for garment factories, printing and dyeing mill, food plants, beverage plants. 10 tons SZS gas steam boiler. The technology is based on the original condition of technology, we make the improvement. So, the new furnace not only inherits the advantages of the old boiler, but also the lack of improvement in the past, so a new generation of boiler operation more convenient, safer, more energy-efficient, energy-saving products is a real sense. Therefore, it is favored by many industries.
Heating gas boiler before the start of the basic operation of gas boiler furnace in operation, to open the main power, to be noted that start-up burner, a gas boiler purge valve in the boiler drum, steam when fully out, and then turn off. When the gas furnace boiler start running, be sure to pay attention to check the observation hole, flanges and valves, is loose, if you find problems in time to tighten, if the problem still find leaks, pay attention to carry out inspection shutdown. 0.05-0.1MPa pressure gas boiler at the time, to pay attention to the issue were pay, sewage, water supply system and sewage screening test device, but also pay attention to the water level table please system; when the pressure rises to 0.1-0.5MPa time , you need to trap gauge for cleaning up; when the pressure is increased to 0.3MPa gas boiler when the "fire load / small fire" switch to the "fire" to strengthen combustion; when the pressure of the gas boiler when the operating pressure rises to two-thirds, to start using heating pipes and were aspirated; and pay attention to open the main steam valve slowly to avoid water hammer phenomenon. When the start operation of the burner gas boiler, to shut down the drain when the valve is fully for emitting steam; when all of the drain valve is closed, and be mindful of the main steam valve was slowly opened to the full, then half a turn, and finally the "combustion control "knob to" automatic. "
In order to maintain the evaporation of the boiler, the same air-fuel ratio to warm Changsha basis having increased fuel and air, flue gas flow increases, due to constant flow area of the flue, where the flue gas velocity superheater is also increased, in accordance with the steady state force guidelines have convection equation, the effect of increasing the flow rate of the flue gas side is the convective heat transfer coefficient of n-th power of the gas velocity, n = 0.6-0.65.