chain grate catalogue industrial oil gas fired boiler
Factors affecting the energy saving heating chain grate catalogue industrial oil fired boilers What are the reasons 1, strictly control the temperature of the boiler exhaust gas boiler heating some of the heat loss, exha reduce flue gas heat loss is an effective way to achieve energy-saving heating boilers. There is a certain temperature difference between the outdoor air temperature and the exhaust gas temperature. When the outdoor air temperature is lower than the exhaust gas temperature, exhaust heat loss is generated. Accordingly, the heating boiler exhaust gas temperature should be strictly controlled within the controllable range. If the exhaust gas temperature is too high, if the exhaust gas temperature is too low may increa, it will lead directly to the heating boiler running cost increases, which is due to the increased tail heating surface, so that the exhaust gas temperature as low as possible. In the energy saving work boiler should be carried out technical accounting and economic accounting. Accounting based on the dew point of the smoke, the tail heating surface and heat loss due to the consumption of the metal. 2, the carbon content of the slag reduce heating boiler First, the operation of the heating boiler in order to ensure the heating boiler that burns coal, the coal particle size be controlled, full use of coal resources, while achieving the purpose of protecting the environment. Secondly, reasonably boiler operating parameters adjusted to reduce the carbon content of the slag, that the ratio of coal to air is more reasonable and the coal before combustion in the furnace. Furnace temperature is a key factor in the index reflects a lot of energy-saving operation of the boiler. The carbon content of slag is one of them. In order to ensure energy saving heating boilers, efforts should be made to reduce the carbon content in the slag, timely elimination of negative factors affecting the normal combustion boiler. 3, the outer surface of the boiler furnace control temperature of the boiler size of the heat affected second two factors is the temperature of the boiler outer wall. It is also important for the outer wall temperature of the boiler, the influence of the external surface temperature of the boiler heating boiler. Relatively larger exterior wall area, the higher the temperature of the external walls, the greater the amount of heat to the surrounding environment. To reduce the heat radiation loss of a boiler, the boiler must be controlled outer surface of the body temperature. 4, to improve the thermal efficiency of the thermal efficiency of the heating boiler heating boiler is a comprehensive index of energy-saving measures. Improve the thermal efficiency of heating boilers, but also help to improve energy efficiency and heating boilers. Improve operational level boiler operator, control of boiler operating conditions, timely maintenance heating boilers, heating boilers to save energy. 5, timely monitor the operation of heating boilers timely monitoring of the operation of heating boilers, not only improve the operational efficiency of the boiler, environmental protection can not be underestimated. Different boiler room should take different measures, timely monitoring of the operation of heating boilers. Spread the boiler room should be checked by installing equipment, computer monitor should focus boiler room.
Temperature protection device during the fuel steam chain grate catalogue industrial oil fired boiler over temperature to regulate protective effect of temperature protection is an important procedure fuel steam boiler safe operation is particularly important for the regulation and protection of the boiler temperature of the fuel vapor; at the same time to regulate in the fuel steam boiler overtemperature Protective effects. Conventional boiler temperature protection means is a bimetallic temperature controller. Flame protection: prevent explosion of the furnace, steam boiler fuel flame protection means must be provided, is a function of combustion (including ignition, combustion or misfires when halfway off, typically within five seconds reignition monitoring the furnace, a second the run off into the oil (gas) solenoid valve, and turns on and audible alarm signal, when the blower continues to operate, the residual gas was purged of combustible furnace, after 20 to 30 seconds purge, automatically cut off and various auxiliary blowers supply the boiler operation stops. role is to monitor the flame signal the presence of a flame or an interrupt control apparatus mainly using a photomultiplier tube, a photovoltaic cell and photosensitive resistance, they have an infrared type or ultraviolet type a photoelectric conversion element, the working principle of the light converted to the corresponding strength of the radiation strength of current and the linear output state, sometimes weak induction current, through amplification, in order to have an effect on the controller.
Steam chain grate catalogue industrial oil fired boiler must be shut down? For gas-fired boiler will be some companies: the higher cost of oil-fired boilers and electric heating boilers, many SMEs simply can not afford, the thermal efficiency of the boiler is too low, gas consumption often can not keep up. Many reasons why gas boiler known as the preferred place of the main gas boiler. In business consulting to some customers learned, after being forced to shut down the gas boiler, no steam, the company has only discontinued. In order to survive companies only replace the boiler, to select the gas-fired, oil-fired boiler, electric heating boiler and a biomass pellet boiler. Currently the market for natural gas boilers only major selection, analysis of the reasons is that gas-fired gas boiler is fully automatic, with no pollution. But in reality, many businesses faced to replace the boiler, gas pipeline did not pull in place, some companies simply do not have natural gas pipeline, steam boiler must be shut down? Gas boiler gas boiler, not to mention the natural ventilation. This is the biggest obstacle currently facing.
Using Ultraten wings condensation chain grate catalogue industrial oil fired boiler technology has greatly enhanced heat the heating rate; silicon alloy material design to achieve the depth of the condensing heat exchanger, high efficiency, high heat transfer speed. "APH the T7" ready to use the factory mode, the system design is simple and clear, i.e. security that is used, the best burner performance debugging the factory, the user can simply set up at the installation site, connected to gas, water, to a flue , it covers an area of greatly reduced.