chief inspector of boilers haryana
The maintenance of horizontal coal fired chief inspector of boilers haryana is the same with the water level, which can use mutiple preservation:
1. The pressure control
Method: 1, first, the pickling operation is started, the chief inspector of boilers haryana economizer, in addition to filling the drum with brine and water wall. 2, the ignition operation of the boiler, the boiler when the temperature rises to 70-80 deg.] C, the boiler flame, pickling may be performed thereafter. Before pickling, but also with superheater backfilling demineralized water, until the water until the overflow into the drum, to prevent the acid or acid-introduced into the superheater steam damage. 3, when the acid charged to the boiler, in any case, should not be firing boiler. Drum discharge hole and the other should be opened to discharge the generated acid and iron reaction of hydrogen, hydrogen has dissipated before sure to avoid the use of open flame or electrical sparking device to avoid risk of explosion of hydrogen. 4, finally, after the completion of filling the acid, so that the boiler economizer and soaked in the solution for about 6 hours, and then the acid is discharged, and rinsed with demineralized water superheater. Acid discharged after the acid drained, operating boiler feed pump, a water economizer capacity charged boiler feed water shut-off valve to prevent leakage.
Our hospital requirements for environmental protection, health and safety in these areas is very high, for a wide variety of market chief inspector of boilers haryana is also very headache and confusion, there fast boiler solve the above problem, the boiler set clean environment to provide for our hospitals and efficient operation in one, coincides with the philosophy of our hospital. --customer feedback
Factors affecting the thermal efficiency of gas chief inspector of boilers haryanas What? 1, exhaust gas temperature: the temperature of exhaust gas boiler is generally increased by 15 degrees, heat losses will be increased by 1%. 2, the oxygen content of the furnace: the excess air factor, when an excessive increase in heat losses, is too small incomplete combustion loss increases. 3, furnace pressure: positive pressure when the furnace operating conditions reasonable time, can effectively avoid the intrusion of the cold hearth, a negative pressure may increase the air ratio to increase the exhaust loss; 4, insulation factor: this factor mostly caused overhaul , when the boiler is located somewhere in the inner part faulty insulation, insulation must be removed for repair, the repair is completed after the insulation layer can not be repaired, resulting in increased heat boiler heat loss. 5, piping: soda pipe, gas pipe and smoke is no need to have some air pipe bends and valves, increasing the resistance to fluid flow in the pipeline, at the same time, some of the valve system is not fully open, to form a fluid expansion, increasing the local resistance loss of the working fluid.