Recently, the Longhai carried out safety campaigns to the boiler, the campaigns start from the four directions, whether units in accordance with the boiler 'boiler safety practices "to use the correct boiler conducted a comprehensive inspection.

First, the unit register in a boiler boiler inspection. The use of units to crack down on unauthorized use of untested or failed the inspection of boilers.

Second, the units are equipped with a boiler if the security officer and fireman personnel. Focus on checking whether the use of units as required "special equipment operator assessment rules," the fireman with security personnel and staff to meet the requirements, and whether the person has made fireman fireman card.

Third, in the boiler unit will be the safety management system, emergency plans to check the system; and to convey the importance of this inspection in the boiler unit, raise awareness of security units.

Fourth, strengthen supervision of energy-efficient boilers, boiler and actively promote energy efficiency testing, at present, boiler energy efficiency testing has been completed a total of 112 units.

To date, the Longhai inspection operations were dispatched inspectors 209 passengers, checked boiler unit 136, check the boiler 168 units, eliminate safety hazards at 9, and urge the use of sealed units to enhance the energy efficiency of boilers 21 units.

And with the Commission by letter, and environmental protection departments to further promote the comprehensive upgrade of coal-fired boiler energy saving project, disable the coal-fired boiler 53 units, 34 units scrapped, replaced by raw material boiler fuel and natural gas fuel of a total of 40 units, is out of the city coal-fired boilers to make a positive response.

Low nitrogen emissions is one of the important decision-making environmental development of our country, under the general trend, low nitrogen gas boiler has become a darling of the market. According to our fast boiler understood that, since 2016, Beijing will expand the transformation of low nitrogen gas boiler, and then, one by one to keep up with our other provinces, more stringent emission targets, the transformation of low nitrogen gas boiler without delay.

Your steam boiler is running properly, look at the work of the water table, right: in a steam boiler, the water level in the boiler to detect whether the table is the basis for safe and stable operation; real-time display of boiler water level, dynamic monitoring internal boiler so that the boiler water level control in the normal range. In many cases, the water level by looking at the table working condition, you will be able to determine the steam boiler is running properly. Therefore, each of the following safety testing method is particularly important. 1, each steam boiler at least two water table, ensure that they can be used normally. 2, where the water table mounted easy to observe, illumination must be provided. 3, operation of the ground water table from above 6m, the remote installation of the water level display device. 4, direct-reading water meter must be clearly marked to ensure the highest and lowest security level and normal water level (red bar) during normal use of the water table. 5, the lower portion of the visible edge of the water table is lower than the minimum security level at least 25mm, at least higher than the upper edge of the visible maximum safety level 25mm, normal water level in the middle of the table. Second, the method proper operation of the water level in Table 1, the water level table clearly show the normal water level, wash at least once per shift, to prevent false water level; 3, the water table has drainage valve, and a discharge pipe to a place of safety; 4, water table drum soda connection between the valved pipe, the boiler must be run when the valve in the fully open position; 5, soda water table between the drum and the inner diameter of the connecting pipe is not less than 18mm, the inner diameter of the glass tube and water gauge valves flow channel diameter is not less than 8mm.

Second, the electric boiler is mainly composed of a body, the electronic control box, the control system and various power cable. Maintenance of these components, the control should be checked once in two months, and for the electric boiler burners, the process requires the use of every two months to remove some of the removed dust, etc.; surface is required for each photocell It may be wiped once; in addition to the filter in the pump, but also carry out regular checks. But be warned: Do not destroy the sealed pad to avoid damage to the pump.