customized oil or gas burner for thermal oil boiler
Jinzhou construction and installation company needs an electric heating hot water customized oil or burner for thermal oil boiler house construction, after screening and comparison of various brand boiler industry, our excellent results in the cleaning of the boiler industry has been attracted to each other, in mid-2016, the Jinzhou construction and installation the company I signed with an electric heating pressure hot water boiler.
Different meaning of the data and the oxygen content of the exhaust gas fired customized oil or burner for thermal oil boiler: A boiler oil-fired boiler which, it is explained below target, because through knowledge and understanding of this kind of boiler, can broaden everyone's knowledge, and at the same time, familiar with the different boiler type, so as to achieve a comprehensive understanding of the boiler, do not miss any of which. 1. fuel boiler, 0.5 tons and 0.35mw, its meaning is the same as you? An oil boiler, and 0.5 tons 0.35mw these two parameters, which specifically refers to, and is not the same, because the former is the rated evaporation of the boiler, while the latter refers to the rated power of the boiler or the rated for heat. In addition, in the unit, the two are not the same. So, obviously, on this issue, that the answer is not the same. 2. Industrial boilers, oil-fired boiler is why the general level? In addition, the oxygen content in the exhaust gas boiler fuel, how much is more appropriate? Industrial boilers, if its use is oil-fired boiler, then, it generally is a Class B boiler, that is, the pressure of the boiler is rated at 2.5MPa or less. Oil-fired boiler exhaust gas oxygen content and, in general, is controlled within the range of 3% to 5% is appropriate. If less than 3%, the problem of incomplete combustion occurs.
How to set the height of the customized oil or burner for thermal oil boiler chimney
The coal fired boiler can be divided into two kinds：vertical boiler and horizontal boiler. And the horizontal boiler is very economic because of its long flue gas flow, slow smoke discharge, high heating efficiency. So it is widely sued in the market. After buying a boiler, it is necessary for them to build a boiler room,in the installation the height of the chimney also need to pay attention. According to the ZG engineer, the chimney height should be accordance with the lowest height of GB13271-2001 stipulation. Only one chimney is allowed in a boiler room. The specific requirements was listed below:
1.When the boiler’s output capacity is more than 1t/h or 0.7MW, a permanent thief hatch and relevant facilities should be setted in compliance with the stipulations of measuring method for smoke and dust of boiler emission, and The determination of particulates and sampling methods of gaseous pollutants emitted from exhaust gas of stationary source.
2. The exit diameter of the chimney should be not lower than the largest load. The smoke flow should not be too fast. when the load of the coal fired boiler is at its lowest level, the velocity of the chimney exit should not lower than 2.5~3m/s.
3. If the chimney heat does not reach the height of the above stipulations, the maximum discharge concentration of the dust,sulfur dioxide, nitric dioxide should be carried out at 50% of the corresponding area and time emissions standard .
WNS oil gas fired horizontal steam customized oil or burner for thermal oil boiler
Trust The horizontal boiler Experts at ZG Boiler