czech republic boilers manufacturers
Coal-fired industrial czech republic boilers manufacturerss need to pay attention to what the transformation of coal-fired industrial boilers need to pay attention to what 1, before removal of the original boiler transformation of the original boiler should be removal of the original main and auxiliary boilers, special demolition work carried out by professionals, so that the whole demolition work done faster to prevent accidents during the removal process. 2, note that the pressure of the boiler, the boiler combustion medium small conversion to gases, but also the original draft combustion into the combustion pressure. In this process, the user needs to pay particular attention to the structure of the whole furnace walls and seal. If the sealing performance is not good, can not withstand the pressure of the boiler, accidents will happen. 3, furnace conversion factor; in many cases the gas burner for the time, because the fuel atomization poor or incomplete combustion furnace gas surplus will be subject to any influence of fire or explosion caused by carelessness, so the transformation is complete should be appropriate where blast doors were installed to prevent the explosion, while increasing the ignition flameout protection device to ensure the safe operation of the boiler; 4, after the transformation test, the need for complex trials to determine the safety after the transformation of high-quality boiler sex. Common method of detection is the pressure after the high-pressure water boiler transformation test. Finally, only after the tests meet the standard, boiler to complete renovation work.
Notes czech republic boilers manufacturers blowdown and the specific steps boilers use a long time there will be all kinds of dirt, these vexing dirt may also affect the use of the boiler, the boiler should be how to clean up the dirt of it? What issues should pay attention to it? Described briefly below: 1. In order to prevent the water inside the boiler slag scale accidents caused by it, we must ensure that the internal flow of water quality, water alkalinity reduction furnace, when the furnace water alkalinity greater than 20 mEq / l, should be sewage. Note that when the sewage: 1, when two or more than two boilers use a sewage, the sewage is prohibited simultaneously. 2, if a boiler in the repair, so that the boiler should be isolated from the manifold open. 3, blowdown, the water level should the boiler at high and low loads. Second, the blowdown steps: 1, open the drain valve, preheated sewage mains, pipelines After preheating, the big valve, the discharge is completed, immediately close the drain valve. 2, blowdown, if there is an impact sound in the outfall passage, the discharge valve should be closed immediately until small sound disappears, and then slowly open the valve play, sewage for too long, the drain valve is fully opened time is generally not more than 15 seconds , so as not to affect the boiler water circulation. 3, sewage and cycle emissions should water quality monitoring personnel to determine the general sewage class at least once a regular basis. These are the boiler blowdown precautions and specific method, if it is found to be timely boiler fouling detergent treatment, if ignore them, over time, it will not only affect the efficiency of the boiler, but also a security risk.
As for the czech republic boilers manufacturers layout, we have traditional horizontal type and novel vertical type coking waste heat boiler. The vertical type is a new patent coking waste heat boiler developed independently by our company, with novel structure and good performance.
Using Ultraten wings condensation czech republic boilers manufacturers technology has greatly enhanced heat the heating rate; silicon alloy material design to achieve the depth of the condensing heat exchanger, high efficiency, high heat transfer speed. "APH the T7" ready to use the factory mode, the system design is simple and clear, i.e. security that is used, the best burner performance debugging the factory, the user can simply set up at the installation site, connected to gas, water, to a flue , it covers an area of greatly reduced.