high temperature hot water boilers for sale
Let's take a look at the corrosion of the boiler. Do not control the supply of water, the system of hot water for baths, laundry, etc., a 2.8MW high temperature hot water boilers for sale, daily replenishment of nearly 100 tons. The "Water quality Standard for low-pressure boilers" is not carried out conscientiously, and it is clearly stipulated in the standard that when the water supply temperature is ≤ 95 ℃, the PH value of circulating water should be controlled to 10-12, which is a very important indicator, but some units do not implement it. Mistakenly supply hot water boilers according to steam boiler water standards. Heating network pipeline installation is not qualified, circulating water can not be delivered to the end of the system users. If you increase the number of times of air discharge, the drainage will be hot, the drainage will be cool, and the result will be increased Big leaks.
The party high temperature hot water boilers for sale output fast enough to provide high efficiency, give us save a lot of fuel costs, and exhaust gas discharged tested in full compliance with environmental regulations on emissions of air pollutants in Henan Province. Fast boiler responsible attitude also left us with a deep impression, overhaul maintenance problems for a number of aspects of boiler operation and post, sent a very professional technical staff and our butt, fireman guide our people, for the quick sale of party, we are also very satisfied. --customer feedback
When the boiler heat load is gradually increased (e.g., above 30% rated load), increase flow through the screen steam superheater tube wall will not be sufficient cooling, a higher temperature tends to the wall, even over temperature. At this time, the steam temperature should be adjusted using a desuperheater can reduce the inlet temperature of the platen superheater, increased flow through it and its subsequent heating surface of the platen superheater safety factor is improved.
When the amount of steam used is small, the remaining steam is put into the container through the nozzle, so that the water temperature and pressure in the accumulator are gradually increased until the saturation temperature at the rated pressure to complete the storage of heat energy. When the steam usage increases, the steam is supplied by the accumulator, and the pressure in the accumulator decreases. The working pressure of the accumulator is limited by the pressure of the boiler. When there is a great difference between the rated pressure and the steam pressure of the boiler, there is more steam produced by the unit volume of the accumulator, and the economic benefit of using the accumulator is high. When using the heat accumulator, the boiler with higher working pressure should be selected, and the steam department should be divided according to the different pressure, and the steam pipeline should be arranged respectively. Improve the economic performance of the heat accumulator.