inlet pressure of three-ton industrial boiler
Boiler outdoor detection means mounted matter detection device can acquire the outdoor temperature of the outdoor will transmit a signal to the control room inlet pressure of three-ton industrial boiler, the boiler operator may then adjust the output power of the boiler, to heat buildings better. Detecting means attached to outdoor some caveats, the following is a specific description. Correctly installed outdoor temperature is the basis of the detected control function. The detector must be installed outside the building heating, 1/2 height of the wall, facing north or northwest direction, away from the local flue, doors, windows and direct sunlight. 1, the detector should be mounted on a smooth, flat wall 2, the maximum length between the detector and the control panel are an outdoor 50m3, any user connection cable conduit must be away from the power cord (230v) 4, the detector and the control panel can not have joints between the wires, if unavoidable, these joints must be well outside the probe seal mounting step 1, the detector opens the protection cover, is an adapter plate is rotated counterclockwise and the fixing hole. 2, find a fixed point as a template with a protective case. 3, removed the protective box, punching, use of the expansion plug. 4, two plugs using the supplied protective box fixed to the wall. 5, two wires connected to the connection plate, no need to determine positive and negative. 6, the cable seal tightening nut sleeve, close protection cover. Outdoor temperature controlled heating profile formed water temperature set point for the water temperature to maintain a certain level. Adjust the heating profile in different ways can be used to meet the heat output and room temperature. When the heating curve slope increases, the water temperature as the outdoor temperature decreases. Or, in other words, if the indoor temperature is not displayed correctly when the cold outdoors, is displayed correctly when the outdoor temperature is high, the heating curve slope must be re-adjusted. Increase slope: especially when the outdoor temperature is low when the water temperature increase. Reduce slope: especially when the outdoor temperature is high, reduce the water temperature. Set the heating chamber 20 is a graph of reference, such as the set point changes, it will automatically change the heating curve. Heating curve parallel displacement for changing the average flow temperature of the day, in other words, if the room temperature is too high or low, must be parallel displacement curve. The condensing boiler control automatically the heating curve to apply to the weather conditions, without resetting the heating curve slope, as long as can be on or off. To use this feature, the following points must be observed: 1, must be connected to the indoor sensor 2, 3 indoor setting change must be selected between 1 and 99, with reference to a thermostatic chamber without installing radiator valves, with reference to the sensor chamber is to install an indoor place (the installation of such a valve must be fully opened or closed if the sensor is used indoors, the compensation variable weather compensation function is activated by this parameter.
Affect gas hot water inlet pressure of three-ton industrial boiler consumes much what reasons which affect the consumption of gas hot water boiler big reason? The most fundamental reason is that the impact of energy for hot water heating lack of unified planning, the lack of comprehensive analysis and understanding of the problems in programming, hot water boiler heating planning, new construction planning and programming co-production film lack of awareness. For residential construction, it is also a state of use of all available space, scattered around a small hot water boiler heating has become the only expedient; hot water boiler room of small-scale, small-capacity is the root cause of energy consumption. Second, there is a design problem. In the design of the heating, since the emphasis on safety considerations, the design heat load of the calculation results is generally greater than the actual need, and the gas hot water boiler, the radiator and the water pump is greater. Due to unfavorable phenomenon of low load, flow, etc., designers analysis of the pipeline construction is not deep enough, the production of boiler does not fully take into account the potential problems. Technical staff of the department issues boilers are key issues. However, after recent years of technology innovation, with a lot of practice and test some of the problems gradually improved, common understanding has also made great progress in the design and practice more and more unified. Finally, gas hot water boiler low level of management is the problem. Currently, there are two main heating operation and management: housing construction sector management and self-management units. In fact, the two management level is not high. Housing construction sector management is relatively good. Considering the quality of the overall running costs and heating units, units of self-management is high energy consumption and low efficiency. The current social problems still taking into account the social benefits of heating, and energy-saving and new technology research and development is still at a relatively slow and extensive economic management situation, it takes some time to improve to good scientific management.
SZL series inlet pressure of three-ton industrial boiler in Tanzania
CBM is a veteran enterprise with more than 70 years of boiler production history in the central and western regions of China. It is a boiler production and research and development base with advanced technologies and production concepts. The boiler products produced by CBM are sold not only to all parts of the country, but also to overseas markets. The products they produce are also sold to many overseas countries and regions.
Young workers from Tianjin, said the training is very timely, went through the last heating period we have a lot of operational settings, fault verification, exclude doubt want to learn the skills, the training targeted and very practical, lecturer lectures easy to understand, is a rare and rewarding "charge" in the hope the group can fast side of this type of open class continue gone out of existence, we have a great need for such training.