steam boilerthermic fluid heaterpower boiler
When use of electric boilers, power costs are: 1 kWh of heat is 860kcal / kWh × thermal efficiency of 90% = 774kcal / kWh; 1 tons of water power consumption of 35000kcal ÷ 774kcal / kWh = 45.22 degrees,
"Thalia T7" The launch will greatly resolve hotels, supermarkets, enterprises and other energy problems and low nitrogen integration, and promote clean heating reform, promote the development of clean heating industry, the posture of the strong start another wave.
The colour for effluent water, water output and water security are totally different. They are respectively designed for red, green, yellow for the convenience of boiler’s installation.
What is the reason of galvanizing oil-fired gas boiler?What is the reason of galvanizing oil-fired gas boiler? The burner of oil-fired gas-fired boiler is the key component of the boiler. It is very important to select the type of burner and whether the boiler is fit, and the control and regulation of combustion are very important. The function of the burner is to organize the good combustion of fuel equipment. Therefore, the fuel should be atomized into fine particles and the oxygen needed for fuel combustion should be supplied at the same time. Therefore, the burner consists of two parts: the fuel supply equipment and the oxygen supply equipment. The computer control system is another main component of the oil-gas boiler, which is equivalent to the brain of the human body, to achieve the uploading of all kinds of commands. If used properly, there are few hardware problems. The furnace body is subjected to high temperature drying The intermediate of baking, transferring heat and producing the necessary heat medium, its working condition is bad, its output is large, its quality determines the length of the whole boiler's life, the material chosen should have greater corrosion resistance and better tensile strength. And good thermal conductivity. More customers will require galvanizing treatment on the furnace body, which will have the following advantages. Zinc is a very active metal that is extremely easy to oxidize, but zinc oxide is not a loose powder like iron oxide, but a dense surface layer. This layer of zinc oxide prevents further oxidation of zinc inside. When the surface of galvanized steel sheet is damaged, dew When it comes to the internal surface of iron, zinc is more active than iron, so according to chemical battery principles, zinc is oxidized prior to iron, thus protecting the iron layer from damage. Therefore, the service life of galvanized boiler will be extended. Secondly, it can prevent the boiler from producing yellow water and affect the water quality. Boiler in the factory pressure test, testing the welding quality of the boiler, in this process there will be part of the residual moisture, the internal relatively wet, will have a slight oxidation. If used in areas of slightly poor water quality, a layer of scale will be attached to the wall of the furnace and pipe wall during use, and the rusty part of the original steel plate will be covered, so there will be no yellow water, if the water quality is less than that of the water. Good area use, in the process of boiler use will not produce scale, the original steel plate rust will not be covered, so yellow water will be generated. There are two sides to the existence of things. Where the quality of water is good, the life of the boiler is much longer than that of the area where the quality of the water is worse than that of the area where the water does not produce yellow water.