A rated working pressure of the szs series fired boiler in canada steam pressure in the boiler should be greater than the sum of the plate for the steam production required for the pipeline resistance and operating pressure. Do not neglect the steam pipe resistance, because the higher rated steam pressure, saturated steam temperatures will also increase. Second, the boiler heating surface heating surface (heat transfer area) is an important boiler (design) parameters. Because of the large output of Boilers generally large overload capability; otherwise, output is small. Same boiler capacity, a relatively large heating area, a lower exhaust gas temperature, the higher the efficiency of the boiler, fuel combustion heat is more fully utilized, consumes less. Third, boiler blowdown boiler blowdown is clean the inside, remove the sludge, reducing the effective measures of scale. Fourth, the construction furnace boiler furnace tube diameter is also one of the very important (design) parameters. After a lot of boiler running for some time in the furnace coke, smoke pipe soot accumulated soot, black smoke even began, will be a waste of fuel. The main reason is the diameter of the furnace small, atomized oil particles had a chance to be injected into the combustion furnace wall caused by high temperature carbonization. Thus, when selecting a gas boiler furnace to select a larger diameter.

0.5 tons gas szs series fired boiler in canada introduced: 0.5 tons of gas boiler Description: 0.5 tons of gas boiler imported burner, automatic programmed control, automatic purge blower, electronic auto-ignition, spontaneous combustion and gas, (air) automatically adjusting the ratio of wind oil good atomization, combustion, low NOX, energy saving and environmental protection. Under normal circumstances, when the boiler steam pressure reaches the set value, the burner combustion is automatically stopped, when the steam pressure is below the set value, the burner is automatically started. When the abnormal phenomenon of the fuel, air intake, fault lights, the output sequencer will immediately stop the fuel, burner shut down automatically.

After installation and commissioning fast Boiler professional and technical personnel, two hot water szs series fired boiler in canadas to provide our bodies quickly into the orbit of the normal operation. Meanwhile, the design of energy-saving equipment also effectively improve the thermal efficiency of the boiler, saved us a huge amount of fuel costs. --customer feedback

What differences have low nitrogen szs series fired boiler in canada with ordinary boilers? We all know now the boiler furnace oil and gas market sell very popular, especially for low NOx combustion of furnace oil and gas is in short supply. However, for many boiler manufacturers, the low nitrogen technology is even more difficult to overcome the problem, the birth of low nitrogen boiler is a milestone, a professional low nitrogen furnace boiler developed by the company's low-NOx combustion technology has been widely used in the industrial boiler application. 1, since the difference in emission layer burning combustion mode, combustion chamber, different circulating fluidized bed boiler, the furnace in different structures, the original NOx emissions which there are large differences, in general, not specifically for low NOX combustion furnace technology employed when , circulating fluidized bed low NOx raw emissions, NOx emissions to the original furnace chain represented slightly lower layer burner, pulverized coal-fired boilers industrial boilers room, the higher the NOx emissions original, well-known low nitrogen emissions from boilers are but Greatly reduced. 2, the different layers combustion boiler technology, combustion chamber, circulating fluidized bed boiler may be different with different low NOx combustion technique in accordance with the combustion mode, the combustion boiler for the air distribution layers using an air classifier, and more often to achieve low nitrogen Gas Recirculation combustion; under typical flue gas recirculation layer influence combustion boiler combustion zone, in conjunction with the air fractionation techniques for reducing NOx by catalytic char; super reduction furnace denitration technology in recent years, new furnace denitration technology, by combustion reasonable location of the flame spray region ammonia, direct denitration at a high temperature flame. Low Nitrogen mainly the secondary air boiler, the coal to the location and distribution of optimal adjustment of the mouth, or the like to increase the flue gas recirculation system. 3, at different central security layer after combustion, combustion chamber, low-NOx combustion furnace circulating fluidized bed boiler technology a large number of tests performed, it has been verified in engineering applications, in general, a low nitrogen boiler to safety higher, the reason why in recent years, its sales volume increasing, there are many users because of its high security, a small threat to the space environment to buy, and this is one of its important differences with ordinary boilers.