verticalposite boiler for hospital
How to choose Industrial Boiler
In order to achieve certain temperature conditions in the process of production and manufacture, metallurgical, chemical, food processing and other industries often use some high-quality industrial boilers as heating equipment, and the stability and safety of the operation of these equipment, There are even environmental protection and durability of enterprises have attracted wide attention. So for the enterprise, how can we choose a high-quality industrial boiler?
1, the choice of reliable boiler quality means that the material of industrial boiler itself should be able to withstand any environmental use, which requires the material of the selected industrial boiler to reach a certain level. At present, the excellent steam industrial boilers are forged by 360Ti stainless steel. They have good corrosion resistance in the heating process and can keep stable operation in the long-term uninterrupted heating state.
2, it is necessary to select the industrial boiler with large water capacity because the continuous heating is needed in the industrial production process, which requires the industrial boiler to have the characteristics of continuous and stable heating. The selection of industrial boilers with large water capacity can ensure that the water level fluctuation in the industrial boilers is small, and the heat transfer efficiency of the whole equipment will be more adequate and the heat transfer efficiency will also be higher. And this point the enterprise can obtain the corresponding information according to the product specification or consult the manufacturer.
Behind honor, it is thousands of times persist and exploration. Keep trying, and failed to improve, we have a number of scientific and technological problems. The launch of China's first low nitrogen verticalposite boiler for hospital and stable operation in 2014, Beijing Huairou APEC venue for the realization of "APEC blue" to contribute their part. Respond positively to national policy, contribute to the cause of environmental protection. Group focus on lower nitrogen oxide emissions, a low nitrogen introduction of multi-type boiler. Existing "Thalia", "Willie sharp" and other series, the successful implementation of nitrogen oxide emissions below 18 mg / cubic meter, this data is far below the national existing standards (such as the most stringent in Beijing the implementation of 30 mg / cubic meter standard), is widely used in national important organs of the CPC Central Authority, the national Tourism Bureau.
Setting the main body structure in accordance with the verticalposite boiler for hospital load and design coal rated load, when the load is normal, the device can operate stably. But because there is a temperature difference at the time of the operation, so in order to ensure the safety of the operation, it is necessary to reduce the load. If the load is too low, then the furnace can not fully burn, it will lead to burn center offset, then it will cause a lot of problems. Literacy workers to carry out any work are inseparable from the people, in order to ensure the normal operation of the boiler, first thing to do is to ensure that workers have a higher level of work and professionalism. In the actual work, we found that interfering elements equipment safety of many, it causes effects, there are many, when the boiler fails to be taken reasonable solution also required depending on the fault to select the corresponding solutions, and therefore it requires workers must have a high level of technology. If control is unreasonable, it will face a lot of security risks. Boiler Slagging
When adjusting the gas verticalposite boiler for hospital, the secondary control if the wind speed is too small, it will lead to too close the gas fire, the burner nozzle leading to excessive heat deformation until failure. Further, when adjusting the level of the gas boiler load changes in time, the upper secondary seal vents not cooled, so that the burners are also burning.